BodyFix Clay Wrap Kit 10-14 days

BodyFix Wrap Kit instructions:

– Simply dry brush or exfoliate the areas you wish to treat. (Optional).

– Then ensure the area to be treated is clean and dry and no creams or lotions are on the skin so that the pores are open and are ready to receive the clay.

– You then must decide which areas you wish to wrap. You may want to wrap your full body, just a partial area or spot treatments. For full body wraps we recommend you start at the ankle and work upward wrapping the entire body and partial body wraps could include your legs, arms, stomach or hips.

– Simply measure each body part and record the results. The tape measure should be wrapped firmly on dry skin, but not too tight. We advise you always stand in the same position (arms up or down) for accurate re-measuring after the wraps.

– Smooth a thin layer of clay (approximately 2mm thick) over the whole area to be treated, massaging firmly into the skin, then apply the bandages (warmed, if possible) on the lowest part of the body and work upwards, wrap the bandages firmly but not too tight.

– Then put on a blanket or a warm robe and relax in the wrap for 60 minutes (or 10-20 minutes if wrapping your face or neck).

– After 60 minutes remove the bandages in reverse order. You can wash the bandages and re-use them for your next body wrap treatment.

– Finally, re-measure all of the areas that were wrapped, and calculate your total inch-loss figure. There is no need to shower, as the clay leaves the skin feeling smooth, and the effect of the wrap is enhanced if the solution is not washed off right away.